Bilt Hamber Touch System Bundle:

Bilt Hamber Touch Less:

TOUCH-LESS is our new eco-friendly pressure-washer, pre-clean, snow foam which can be applied by pump spray or trigger too. Applied at between 0.5% – 2% PIR this bio-degradable sugar-based product provides truly exceptional levels of cleaning of automotive paintwork. Unlike other petrochemical-based cleaners TOUCH-LESS is free-and-easy rinsing, easing the effort of subsequent bucket washes and massively helping post-treatments bond too. TOUCH-LESS also contains corrosion inhibitors. Packed in a 1 litre bottle, contains no phosphates, solvents, NTA, or caustic soda.

TOUCH-LESS is designed to allow for superior and simple application of our new paint protection product TOUCH-ON.

How to use:

TOUCH-LESS may be applied with trigger spray, pump spray, pressure washer, or snow foam lance. The minimum recommended dilution rate should be 0.5% PIR (Panel Impact Ratio) and up to 2% for very dirty vehicles. Where application is through trigger spray or pump spray, the dilution calculation is easy to achieve, however, for application with pressure equipment it is essential to determine the amount of water being delivered to the equipment reservoir.

• Step 1: Fill the detergent bottle or reservoir (on machine or lance) up to capacity with plain water. Turn detergent feed to full. Take a large bucket or container and discharge the lance into this, watching the detergent bottle until empty. Once empty, stop.
• Step 2: The following calculations will achieve 2% dilution; Measure the total amount collected and multiply this number by 0.02 (Total can be measured in either volume with a measuring jug or by weight) this is the amount of TOUCH-LESS to use.
• Step 3: Add the calculated amount from STEP TWO to the pressure-washer reservoir and top up to full with cold water and shake in for a few moments.
• Step 4: Apply touchless to entire vehicle or panel by panel. Allow to soak for 1-5 minutes (but never allow to dry). Power-wash off.
• It is not necessary to use all diluted touch-less in one wash. One litre of diluted product should last 4-5 washes. Apply to cool panels in shaded conditions. Do not allow this product to dry in use. Keep the bottle neck and lid clean.

Bilt Hamber Touch On:

TOUCH-ON is a pressure washer, pump-spray, trigger, or bucket applied durable hydrophobic ceramic paint protection treatment that additionally has low-foaming, powerful detergency for most second stage bucket washes so that you can further clean the paint while simultaneously applying protection following TOUCH-LESS cleaning. Once applied, TOUCH-ON has dirt releasing properties too that works in conjunction with TOUCH-LESS in subsequent wash routines to produce superior contactless results. TOUCH-ON is water based, is not flammable nor contains alcohol or petrochemical solvents. Packed in one dose sized 30ml sachets in packs of 10, and 1ltr containers.

How to use:

Vehicle must be cool and out of direct sunlight. Pre-wash with TOUCH-LESS cleaner to remove dirt or contamination on your paintwork. If further cleaning is required use AUTO-WASH concentrated shampoo and noodle wash mitt.

There are three methods that can be used to apply TOUCH-ON:

• Pressure washer:
  Add 30ml into washer or lance reservoir, top up to
  300ml with clean cool water. Shake well and apply
  under pressure to entire vehicle. Immediately rinse
  using pressure washer. Dry vehicle with a
  microfibre cloth or similar. Alternatively, an air
  blower can be used.
• Bucket:
  Pour 30-60ml into a bucket then fill with 10 litres of
  warm water (preferably from a fast running tap), mix
  well. Apply using noodle wash mitt, sponge or
  similar. Rinse with clean water. Dry with a
  microfibre cloth or similar. Please note, this is not a
  high foaming bucket wash.
• Trigger spray:
  Add 30ml to trigger bottle and top up to 1 litre with
  (preferably demineralised/deionised) water. Shake
  well. Trigger apply liberally, panel by panel, then
  thoroughly rinse with pressure washer or hose. Dry
  with microfibre towel or air blower.

Car must not be allowed to air dry as water spotting
may occur.

Includes: 

• 1x 5L Bilt Hamber Touch-Less.
• 10x 30ml Bilt Hamber Touch-On.